Panasonic TX-28WG25 series

STILL
STILL
The Still function can be used to
freeze the action on the screen and
display a still picture of the Sub
picture.
AUDIO SWAP
Push the “STILL” Button to freeze
the moving picture into a still
picture.
Push again to cancel.
Sub picture Programme Number
I A I Selection
Push the Sub picture Programme
Number Up “a” or Down “v” Button
to select the next higher or lower
tuned channel.
6
SEARCH
Sub picture Channel SEARCH
By pushing this button, it is possible
to search through all programmed
numbers and display a picture on
the sub picture screen.
Channel Search
Number
Push again to stop the channel
search in the desired programme
number.
AUDIO SWAP
The AUDIO SWAP button is the
changeover button for the sounds
(audio programme content) of the
MAIN and SUB Picture.
Push it to hear the sound of the
SUB Picture. However, note that
the sound of MAIN Picture can not
be heard when the SUB Picture
sound is selected.
Push again to cancel.
3 3
< 1 >
aa
Position Buttons
By pushing each “Position" Button,
you can easily select the desired
position of the Sub Picture on the
screen.
Note:
By pushing the Normal “N” Button
while the picture in picture mode is
activated, the Sub Picture position
will move to the bottom Right
corner.