Panasonic TX-28WG25 series

Battery Installation
1
Open the cover.
Apply slight downward pressure while pulling towards the
bottom.
2
Two “R6 (AA)" size
Batteries: Use two ''R6 (AA)” size batteries.
Insert the batteries ensuring correct polarity.
This is identifiable by the “+” and symbols on both the
batteries and inside the battery compartment.
Replace the cover.
Do not use rechargeable (Ni-Cd) batteries.
They are different in shape and performance and may fail to ensure correct operation.
A\ Battery cautions
The incorrect use of batteries can cause electrolyte leakage which will corrode the Remote Control or cause the
batteries to burst.
Old Batteries New Batteries
Replace both batteries at the same time.
Don’t mix battery types
(alkaline with carbon zinc, etc.)
Don’t Recharge.