Panasonic TX-28WG25 series

Connecting 3D Woofer Speakers
Connect the 3D woofer speaker as follows.
When a 3D woofer speaker plug Is inserted Into the 3D woofer terminal.
1. Fix the 3D woofer speaker to the position as 2. Insert the 3D woofer speaker plug into the 3D
shown below. woofer terminal.
Connect the Plug to the Wall Outlet
Note:
Mains plug types vary between countries.The mains
plug shown at left may therefore not be the type fitted
to your set.
When connecting the mains plug to the wall outlet, the
power indicator will light (Orange).
How to Turn the Power On _
Push the Power Switch on the Television to turn the
set on.
The Power Indicator will light.
Power-OFF.Orange
Stand-by 6.Red
Power-ON.Green
Note:
When in the Stand-by condition (Refer to page 30), it is
possible to turn the TV set on by pushing the “Power
(Stand-by)” Button or the “Direct Programme Number
Selection” Buttons (0-9), Programme Number Up and
Down Buttons either on the TV set or Remote Control.
Power Switch