Panasonic TX-P65VT60E - Service Mode; Entering Service Mode Procedure; Service Mode Navigation Key Commands; Service Mode Adjustment Parameters and Settings

6 Service Mode
6.1 How to enter into Service Mode
6.1.1 Purpose
After exchange parts, check and adjust the contents of adjustment mode.
While pressing [VOLUME ( - )] button of the main unit, press [ RED ] button of the remote control three times within 2 seconds.
Note:
Service Mode can not be entered when 3D signal input.
Input 2D signal to enter Service Mode.
6.1.2 Key command
[1] button...Main items Selection in forward direction
[2] button...Main items Selection in reverse direction
[3] button...Sub items Selection in forward direction
[4] button...Sub items Selection in reverse direction
[VOL] button...Value of sub items change in forward direction ( + ), in reverse direction ( - )
6.1.3 How to exit
Switch off the power with the [POWER] button on the main unit or the [POWER] button on the remote control.
6.1.4 Contents of adjustment mode
 Value is shown as a hexadecimal number.
 Preset value differs depending on models.
 After entering the adjustment mode, take note of the value in each item before starting adjustment.
Main item
Sub item
Sample Data
Remark
ADJUST
CONTRAST
277
COLOR
36
TINT
00
SUB-BRT
800
H-POS
0
H-AMP
0
V-POS
0
V-AMP
0
WB-ADJ
R-CUT
80
G-CUT
80
B-CUT
80
R-DRV
EE
G-DRV
FF
B-DRV
86
ALL-CUT
80
ALL-DRV
FF
OPTION
Panel-Type
65FHD
Factory Preset
Boot
ROM
STBY-SET
00
EMERGENCY
ON
Page 1 of 7
1/3/2017
file://C:\Users\sh.dehghani\Desktop\New folder\TX-P65VT60EALLSVC_PCZ1304099CE\
...