Panasonic TX-P65VT60E - Page 38

9.2.31 Remove the C2-Board
1. Disconnect the flexible cables (CB6, CB7, CB8, CB9, CB10 and CB11).
2. Disconnect the flexible cables (C20, C21 and C26).
3. Disconnect the connectors (C24 and C28).
4. Remove the screws (×6 ) and remove the C2-Board.
9.2.32 Remove the C3-Board
1. Disconnect the flexible cables (CB12, CB13, CB14 and CB15).
2. Disconnect the flexible cables (C31 and C36).
3. Remove the screws (×4 ) and remove the C3-Board.
9.2.33 Replace the Plasma panel
Caution:
Remove the Plasma panel section from the servicing stand and lay on a flat surface such as a table (covered by a soft cloth) with the Plasma panel
surface facing downward.
A new Plasma panel itself without Contact metals is fragile. To avoid the damage to new Plasma panel, carry a new Plasma panel taking hold of the
Contact metals.
1. Place a carton box packed a new Plasma panel on the flat surface of the work bench.
2. Open a box and without taking a new Plasma panel.
3. Attach the Cabinet assy and each P.C.Board and so on, to the new Plasma panel.
Page 14 of 14
1/3/2017
file://C:\Users\sh.dehghani\Desktop\New folder\TX-P65VT60EALLSVC_PCZ1304099CE\
...