Setup
TQBS0166
59
Remote device list
• To register equipment manually
1 Select the device name or the MAC
Address for the device you want to
register, then press [OK].
2 Select “Yes”, then press [OK].
• To deregister equipment
Select the registered equipment, then
press [OK].
• This function cannot be enabled when
“Automatic” is selected in “Registration type for
remote devices”. (> 58)
• The maximum number of equipment that can be
registered is 16.
DVB-via-IP Server Function
DVB-via-IP Server
Turn on/off the DVB-via-IP Server function.
• If “On” is selected, the setting for “Quick
Start” is fixed to “On”. (> right)
Network Function Priority
It is not possible to use the DVB-via-IP
Server function and another network
function (Network Service / Home
Network) simultaneously.
• DVB-via-IP Server (> 45):
Priority is given to the DVB-via-IP Server
function. When using the DVB-via-IP
Server function, it is not possible to use
Network Service / Home Network.
• Network Service / Home Network
(> 45, 46):
Priority is given to other network functions.
When using the DVB-via-IP Server
function, if you use another network
function on this unit, the former stops.
Legal Notices
Displays the terms of service.
Your use of internet-enabled functions and software
updates must follow the rules set forth in the
Network Service Terms & Conditions and Privacy
Policy (collectively, “Legal Notices”). Please review
the Notices carefully. To confirm your understanding
and acceptance of the Notices, select “Agree”.
Others
Standby Settings
Quick Start
•On:
It is possible to start quickly from standby.
•Off:
Power consumption in standby is minimised.
(> 69)
However, startup time from standby will be
longer.
• Timer Setting for Quick Start:
“Quick Start” is activated when the set time
comes.
• When “Home Network function” (> 58), “TV
Anywhere” (> 58) or “DVB-via-IP Server” (> left) is set
to “On”, the setting for this function is fixed to “On”.
• If “Off” or “Timer Setting for Quick Start” is selected, the
setting for “Front Panel Display” in “Display” is fixed to
“Automatic”. (> 56)
Automatic Standby
When the unit is not operating, the unit will be
turned to standby once the set time has
passed.
Automatic Standby after OTR
•On:
This unit is turned to standby when it is not
operated for approximately 5 minutes after
completion of recording.
Automatic Standby after Copy
•On:
This unit is turned to standby when it is not
operated for approximately 5 minutes after
completing copy.
[UBC70]
[DVB-C] RF OUT ( CATV Signal )
[DVB-T] [DVB-T 2] RF OUT ( Aerial Signal )
Set whether to output the broadcasting signal
from RF OUT or not while in standby (When
“Quick Start” is not activated).
DMRUBC70-UBS70EG-TQBS0166_eng.book 59 ページ ２０２２年１０月３１日 月曜日 午後３時１２分
To Next Page
Loading...
Need help?
General
