Using Speed Dialing
Using One-Touch Voice Mail Transfer
Assigning Names fo PSD Numbers
PSD names are displayed when you dial the PSD number.
1. Pick yp the handset or press ON/OFF.
5. Press AUTO.
6. Enter the voice mail extension number and a password (if
necessary.) If you are accessing a Panasonic Voice Mail,
include a # at the end.
2. Press PROG.
‘
3. Dial #I.
.-
4.-Press AUTO.
5. Dial a PSD code (90-99, or 900-939).
Nule: PSD codes correspond to one-touch keys. Code 90 (or
900) = key 1, code 91 (or 901) = key 2, etc. For example, to
assign a name to the PSD number on one-touch key 1, use
PSD code 90 (or 90 1).
6. Press AUTO once to clear each character in the default name.
7. Enter the first character of the name. Use the information in
For example, if your voice mail number is 500 and you are
not using a password, you would make the following entry:
ON/OFF PROG FF key CONF AUTO 500 #
Note: The length of the voice mail number, including the
voice mail extension number, password, and # cannot exceed
six digits. If more
than
six digits are required, assign the
password to a personal or system speed dial number, then
store the speed dial number rather than your password under
the voice mail key. (See “Using Speed Dialing” on page 16.)
7. Press HOLD.
Using a Voice Mail Key
Table 3 on page 19 as a guide.
1. When the VM key flashes, press it to connect to your
Note: To enter numbers into name, press CONE To resume
entering letters, press CONF again.
mail box.
8. Press FLASH.
Using One-Touch Voice Mail Transfer
Note: This feature requires system programming or a specific
DBS configuration, and may not be available. For infonnauon,
see your system administrator or DBS dealer.
The One-Touch Voice Mail Trausfer key allows you to quickly
transfer callers directly into voice mail.
Assigning a Voice Mail Transfer Key
9. Repeat steps 7-8 for each character in the name until the
entire name is entered.
10. When the name is complete, press FLASII.
11. Press HOLD.
Note:To enter more names, repeat steps 4- 10.
+ n
1. Pick up the handset or press ON/OFF.
2. Press PROG.
3. Press the FF key you want to assign.
To Next Page