How to change the function settings
{OFF}
{PAGE}
{MENU}
{VOLUME}
1 Press {MENU}, then select the desired item by
pressing {VOLUME} (
▲
) or {PAGE} (▲).
2 Press {MENU} (OK), then select the desired item
by pressing {VOLUME} (
▲
) or {PAGE} (▲).
3 Press {MENU} (OK), then select the desired
setting by pressing {VOLUME} (
▲
) or {PAGE}
(▲).
LIn some functions, repeat this operation
according to the display instructions.
4 Press {MENU} (OK).
LIf “INITIALIZE SETTINGS” is selected (page
39), the confirmation message is displayed. To
reset settings, press {VOLUME} (YES).
5 To end the setting, press {OFF}.
Note:
LWhen receiving a call while setting or no operation is done for about 90 seconds, the setting function screen
automatically quits.
Function list of the main monitor station
The default setting is indicated in bold.
Item (function) Setting
CONNECTED DEVICE SETTINGS
DOOR STATION
CONNECTION
DOOR STATION 1: YES, AUTO, NO
DOOR STATION 2: YES, AUTO, NO
LYou can select the setting of the door station.
LSelect “NO” for the door station that is not in use.
LOBBY
CONNECTION*
1
Generally, it is unnecessary to change this setting. This is for apartment
complexes. Only if an optional lobby station is connected to the main monitor
station (page 4), change the setting to “YES”.
YES, NO
DOOR KEY DOOR KEY 1: 2 SEC OPEN, 3 SEC OPEN, 4 SEC OPEN, 5 SEC OPEN,
6 SEC OPEN, 7 SEC OPEN, NOT CONNECTED
DOOR KEY 2: 2 SEC OPEN, 3 SEC OPEN, 4 SEC OPEN, 5 SEC OPEN,
6 SEC OPEN, 7 SEC OPEN, NOT CONNECTED
LYou can select how long the door remains open when the door opener (sold
separately) is connected to the main monitor station (page 35).
AUTOMATIC
ILLUMINATION
DOOR STATION1: WHEN VISITORS COME ENABLE
DISABLE
WHEN MONITORING ENABLE
DISABLE
DOOR STATION2: WHEN VISITORS COME ENABLE
DISABLE
WHEN MONITORING ENABLE
DISABLE
LWith this setting, you can select whether or not to automatically turn on the
LED lights when the area surrounding the door station is dark.
*
1
Cannot be connected to the VL-SW251AZ.
SW251BX_OI.indb 38 9/17/2014 11:05:14 AM