12
Attach to the DIN rail
Attach in the order described below so that hook
(A) is positioned at the bottom.
1 Hang hook (B) on the DIN rail (C).
2 Pull and hold the lever down (D).
3 Secure hook (A) to the DIN rail (E).
Main monitor/extension
monitor installation position
About the installation position of the main
monitor/extension monitor and mounting
bracket
R Place the main monitor/extension monitor in a
location that your eyes are the same height as
the centre of the display.
R For the following reasons, leave at least 20 cm
(A) of space above, below, and to the left and
right sides of the main monitor/extension
monitor:
– To prevent malfunction and sound cutting out
– To ensure to make sure the reset button (B)
can be used (the reset button is on the bottom
of the main monitor/extension monitor)
R After deciding where to install the main monitor/
extension monitor, attach the mounting bracket
in the location shown below.
C Main monitor/extension monitor installation
position
D 121.5 mm
E 58 mm
B
C
E
D
A
1
1
1
2
1
D
E
C
prj_6905-en_gb.book Page 12 Monday, April 24, 2017 6:10 PM
To Next Page
Loading...
