29
■ Basic operation
The following are descriptions of how to configure each setup item using the operation buttons
(refer to p. 10) on the camera. Setup using an optional system controller is also available.
Note:
The illustrations below are the examples to be displayed on a video monitor.
1. Hold down the [SET] button for around 2 sec-
onds.
→ The top page will be displayed.
2. Move the cursor onto "END" by press the
[UP] or [DOWN] button.
3. Press the [SET] button after moving the cur-
sor onto "SETUP" by pressing the [RIGHT]
button.
→ The "DISABLE" indication will change into
"ENABLE" and the settings will become
editable.
4. Move the cursor onto the desired setup item
and press the [SET] button.
→ The setup page of the selected setup item
will be displayed.
5. Configure the settings for each item.
Select setup item: Move the cursor by
pressing the [UP] or [DOWN] button.
Change the parameter: Press the [LEFT] or
[RIGHT] button.
Display the detailed settings page of the
setup item: Press the [SET] button when
the setup item with the [O] mark is
selected.
Go back to the previous page: Move the
cursor onto "RET" and press the [SET]
button.
Go back to the top page: Move the cursor
onto "TOP" and press the [SET] button.
To Next Page
Loading...
