41
• Image stabilization may not function where there is excessive camera movement or when
the scene is low light or low contrast objects.
16. LENS
• When using WV-CW484F or WV-CW484S (with a Panasonic x2 varifocal lens), select
PANASONIC.
• When using WV-CW484FK or WV-CW484SK (with a lens other than Panasonic), select
OTHER.
17. Back-focus Setting (BACK-FOCUS SETUP)
If applicable, perform adjustment of the lens
focus as described in p. 26 "Before Back-focus
Adjustment". Perform adjustment of the back-
focus (flange-back: the gap between the lens
and focal plane) remotely on this menu using a
system controller. After installation, you can per-
form this adjustment when defocus arises that
may be caused by long-term use, environmental
changes, etc.
Important: Do not use the ABF function for continuous or repetitive purposes (ex. autofocus
etc.). This function is to be used to correct defocus caused by switching between color and
black - and - white when/after installing the camera.
1. Select BACK-FOCUS on the top menu and press the [SET] button.
→ The BACK-FOCUS SETUP menu opens.
2. Select ABF and press the [SET] button.
→ Adjustment is automatically performed.
Notes:
• Performing ABF will function to obtain the best focus around the center areas in a
scene.
• Performing ABF is available only when OFF, X2 AUTO, or X2 FIX is selected for SENS
UP.
• Using the ABF function under low light conditions may cause noise.
3. Select MANUAL-ADJ and press the [SET] button if manual adjustment is required.
The manual back-focus adjustment screen will open.
• Use the [LEFT] or [RIGHT] buttons to move the "I" cursor and obtain a proper focus.
→ Refer to the 4-digit number on the second bottom line. The larger the number is, the bet-
ter the focus will be.
• Select RET and press the [SET] button to go back to the menu setup.
To Next Page
Loading...
