23
Special menu setting [SPECIAL SETUP]
The special menu setup is performed including the setting of the camera image quality and the communication configuration when a
receiver is used. The following settings are to be configured on the “SPECIAL SETUP” screen displayed from the top screen.
Refer to page 5 for how to call up the screen.
16. Chroma level adjustment [CHROMA GAIN]
Press the [RIGHT] or [LEFT] button to adjust the color density of the camera image. When the level indicator moves in the “+”
direction, the color becomes deeper, and when the level indicator moves in the “–” direction, the color becomes lighter. Be sure to
view a vector chromaticity indicator or a video monitor when the adjustment is performed.
17. Aperture level adjustment [AP GAIN]
Press the [RIGHT] or [LEFT] button to adjust the image quality. When the level indicator moves in the “+” direction, the image becomes
sharper, and when the level indicator moves in the “–” direction, the image becomes softer. Be sure to view a video monitor when the
adjustment is performed.
Note:
• Moire (interference fringes) may be observed when shooting a subject with fine pattern such as a carpet or a curtain. In such a
case, move the indicator in the "-" direction to reduce moire.
18. Pedestal level adjustment [PEDESTAL]
Press the [RIGHT] or [LEFT] button to adjust the pedestal level of the camera. When the level indicator moves in the “+” direction, the
image becomes brighter, and when the level indicator moves in the “–” direction, the image becomes darker. Be sure to view a video
monitor when the adjustment is performed.
19. Chroma phase (hue) adjustment [HUE]
Press the [RIGHT] or [LEFT] button to adjust the hue of the camera image. Be sure to view a vector chromaticity indicator or a video
monitor when the adjustment is performed.
Note:
• Holding down the [RIGHT] and [LEFT] buttons for more than 2 seconds simultaneously restores the settings of “CHROMA GAIN”,
“AP GAIN”, “PEDESTAL”, and “HUE” to the default settings.
20. Display Settings [DISPLAY]
Move the cursor to "DISPLAY", and press the [RIGHT] or [LEFT] button to change display settings.
OFF: Alarm display is disabled.
ALARM (default): Alarm display is activated.
MOTION DET
Alarm display (“MOTION DET”, “SCENE CHANGE”)
“SPECIAL SETUP” screen
**SPECIAL SETUP**
CHROMA GAIN
...
.
I..160
AP GAIN
..I.... 20
DISPLAY ALARM
PEDESTAL
...
I
... 32
- +
PIX OFF
CAMERA RESET PUSH SET
SER.NO. XXXXXXXX
COMMUNICATION COAX
RET TOP END
HUE
...I... 0
To Next Page
Loading...
