2. Click the [Start] button of “Mask area”.
→ Borders will appear and the image displayed on the [Image quality] tab will be divided into 48 (6x8)
:
• “Mask area” can be set only when “4:3” is selected for “Aspect ratio”. If the “Aspect ratio” is changed
to “16:9” after setting the mask area, the setting of the mask area is maintained.
3. Click the divided areas to be masked.
→ The clicked areas will be masked and will become white. To cancel masking, click the area again.
4. Click the [End] button after completing masking areas.
→ The borders on the image displayed on the [Image quality] tab will disappear.
IMPORTANT
To Next Page
Loading...
