Panasonic WV-V2530LK - Event; Video Detection

58
6.4 Event
Video Detection 6.4.1
VMD 6.4.1.1
The VMD interface is shown as in Figure 6-31.
Figure 6-31
Please refer to the following sheet for detailed information.
Parameter Function
Enable You need to check the box to enable VMD function.
Working Period
Here you can set arm/disarm period. Click on set button to open period
setup menu.
There are six periods every day for setup and you must check box in
front of each period to enable it.
Note: Period setup can be done by dragging mouse while not release
left mouse.
Anti-Dither
System only memorizes one event during the anti-dither period. The
value ranges from 0s to 100s.
VMD area
Here you can set motion detection region and its sensitivity and area.
(The higher the sensitivity is, the easier to trigger motion detect; the
smaller the area, the easier to trigger motion detect.) The default covers
all regions. You must click on save before enabling your setup.
Record
Check it and so when VMD occurs, system will auto record. You shall
set record period in Storage>Schedule and select auto record in record
control interface.
Record Delay
System can delay the record for specified time after alarm ended. The
value ranges from 10s to 300s.