Panasonic WV-X4571L - Indicator Status Meanings

20
ESD MOUNT indicator
⿟ When an SD memory card is inserted and could Lights off → Blinks green →
be recognized Lights off
⿟ When data can be saved after the SD memory card is Lights off → Lights green
inserted and the SD ON/OFF button is pressed
(less than 1 second)
⿟ When data can be saved to the SD memory card Lights green
⿟ When the SD memory card is removed after holding down Lights green → Blinks green →
the SD ON/OFF button (about 2 seconds) Lights off (recording)
Lights green → Lights off
(waiting for recording)
⿟ When data cannot be saved to the SD memory card Lights off
because an abnormality was detected or the SD
memory card is configured not to be used
GSD memory card warning/error indicator
⿟ When a warning status is detected Lights red
*SD memory card warning detection conditions: After the total use time has exceeded 6 years
and the number of overwrite times has exceeded 2000.
⿟ When an error status is detected Blinks red
*SD memory card error detection conditions: Write error, read error, etc.
Note:
⿟ Lighting/blinking LED can be turned off with the software settings at any time. (The initial state is
lighting or blinking.) Set the LED to be solid off if necessary, depending on the installation condi-
tions. (☞ Operating instructions included in the CD-ROM)
⑴When the SD ON/OFF button is pressed (less than 1 second), the SD MOUNT indicator lights
up in green and data can be saved to the SD memory card.
⑵ When the SD ON/OFF button is held down (about 2 seconds), the SD MOUNT indicator lights
off and the SD memory card can be removed.
FSD ON/OFF button
D SD ERROR/ABF indicator
X4571L
X4571LM
SD ERROR indicator
S4550L
S4550LM
⿟ When ABF (Auto Back Focus) operation is being Blinks red (Interval of 1 time/ second)
executed
X4571L
X4571LM
⿟ When the set is being started Lights red
⿟ When an SD memory card is recognized normally Lights red → Lights off
⿟ When the SD card slot is not used or an abnormality is Lights red → Stays red
detected in SD card after the camera has started
Note:
⿟ The default is off. According to the installation environment, set up with software as required.
(☞ Operating instructions included in the CD-ROM)
CLINK indicator
BACT indicator
⿟ When the camera is able to communicate with Lights orange
the connected device
⿟ When data is being sent via the network camera Blinks green (accessing)