11
Operating procedures
w Preparations
Prior to operating the headset, confirm that the system
setup for the headset, Center Module, and other devices has
been completed.
Install a battery in the battery compartment.
(Refer to p. 10 “Battery loading & replacement”.)
Press the [POWER] button to turn on the
power.
p When the power is turned on, the voice messages
“Hello”, “Headset xx” (xx: ID number registered in the
Center Module) and “Lane x” (x: Connected Lane
number) are heard from the earphone.
Wear the headset.
Adjust the head pad so that the earphone is
placed on your ear.
Rotate the microphone boom so that the
microphone is brought to a position near your
mouth.
p It is also possible to attach a strap which is used to
suspend the headset.
Strap
(commercially available)
Note
English
To Next Page
Loading...
