Panasonic WX-LT350 - Page 12

12
• When set to a position other than 1 to 4, the battery indicator will blink.
• Default setting: Function 1-1
Note:
Set the transmitting channels (CH1 - CH4) to match the receiver used, disregarding
Functions 1 and 2. Functions 1 and 2 assigned by the channel select switch are still dis-
abled at this point in time (receiver compatible with these functions unreleased as of June
2009). The following occurrences are not considered as malfunction:
• When setting the channel select switch to [Function 1 (1 - 4)] and pressing the function but-
ton, all of the [OWN], [OTHER] and [LINE] selection indicators light up once.
• When setting the channel select switch to [Function 2 (1 - 4)] and pressing the function but-
ton for 2 seconds or more,
• [OWN], [OTHER] and [LINE] selection indicators: all lit
• Volume control/Muting: disabled
• External input terminal: disabled
• Microphone input terminal: enabled
• Audio input from the microphone opening: enabled (when not using the microphone
input terminal)
To restore to the original status, turn the power of the microphone [OFF/ON].
Receiver
Position
Function 1
[F1]
Function 2
[F2]
1
1
2
2
3
3
4
4
WX-LR100/A, WX-LA20,
WX-LA50, WX-LP100
WX-LR100,
WX-LR100/B
Channel Frequency Channel Frequency
––
––
CH3 3.20 MHz
CH4 3.80 MHz
––
––
CH3 3.20 MHz
CH4 3.80 MHz
CH1
CH2
–
–
CH1
CH2
–
–
2.30 MHz
2.80 MHz
–
–
2.30 MHz
2.80 MHz
–
–