Panasonic WX-LT350 - Channel Setting

11
Channel setting
Set the infrared transmitting channel of the microphone. Set the channels to match the receiv-
ing channels of the infrared receiver, infrared receiver/amplifier, and infrared wireless powered
speaker used. For details refer to the operating instructions of the receiver.
Note that the channel setup of the microphone differs depending on the infrared receiver,
infrared receiver/amplifier, and infrared wireless powered speaker used.
• For WX-LR100/A, WX-LA20, WX-LA50, WX-LP100
CH1: 2.30 MHz
CH2: 2.80 MHz
• For WX-LR100, WX-LR100/B
CH3: 3.20 MHz
CH4: 3.80 MHz
Important:
• Channels can be set up with the power of the microphone turned on, but to prevent noise it
is recommended to turn down the volume of the powered amplifier, mixer, etc.
1
Remove the battery cover of the
microphone.
Pull the battery cover in the arrow direc-
tion while pressing the A portion with
both right and left thumbs to remove the
cover.
2
Set the transmitting channels and
assign functions to the function but-
ton.
To set the transmitting channels and
assign functions to the function button,
use the small channel setting screwdriv-
er (accessory) to turn the channel select
switch until it clicks in place.
The positions of the channel select
switch correspond to the following chan-
nels/functions.
CH
2
1
1
2
3
3
4
F
1
4
F
2
CH
2
1
1
2
3
3
4
4
F
2
F
1
Channel select switch
Battery cover
A