Panasonic WX-LT350 - Replacing a Battery

21
Replacing a battery
• Carefully read the "Precautions" and proceed accordingly.
• To replace the battery, turn off the power of the microphone, and make sure that the micro-
phone is not connected to the charger.
• The following indicates that either the dry cell is depleted or the rechargeable battery has
run out. In this case, install a new dry cell or charge the rechargeable battery.
• The battery indicator lights red
• The battery indicator does not light
Note:
• Do not touch the battery poles with hands. Otherwise poor contact or noise may result. If
dirty, wipe off with a dry soft cloth.
• Battery power is slightly consumed even when the power of this product is OFF. If the bat-
tery is left unused, that may result in liquid leakage. To prevent this, remove the battery
from the product when unused for a long time.
1
Turn off the power by pressing the [PWR/MUTE] button for 2 seconds or more.
Confirm that the battery indicator is off.
2
Remove the battery cover.
Pull the battery cover in the arrow direction while pressing the A portion with both right and
left thumbs to remove the cover.
3
Install a new battery.
When removing the used battery, lift out the + side, then the – side.
When installing the battery, check the polarity.
If using a rechargeable battery, install one AA size nickel metal hydride battery, if using a
dry cell, install one AA/LR6 size alkaline dry cell, paying attention to the polarity marks (+,
–) of the battery slot.
4
Attach the battery cover.
Push up the battery cover to the direction of the arrow in the figure, and fit it to its original
position.
5
Confirm that the battery indicator lights.
Press the [PWR/MUTE] button for 1 second or more, turn on the power of the microphone,
and confirm that the battery indicator lights green or orange.
WX-LT350
CHG
F
BATT
S
E
L
E
C
T
PWR
O
W
N
O
T
H
E
R
L
I
N
E
M
U
T
E
[PWR/MUTE] button
1, 5
Battery indicator
1, 5
Rear view
3
4
Battery cover
2
A