Panda-Audio Future Impact v3 - Page 78

2
VCF volume of Main
Mixer
127
Adjusts (logarithmically) the VCF volume
of the Main Mixer.
When CC2 is at maximum (127) then VCF
volume of Main Mixer corresponds to the
preset value in the program. This differs
from Volume Control (CC7) in two aspects:
1. It only adjusts the synth volume, it
does not change the input
instrument’s volume;
2. It is located before the effects, so
delay trails, etc. will not be muted
when CC2 is at 0.
5
Portamento time
0*/127
*0 in EWI Mode only.
When CC5 is at maximum (127) then this
corresponds to the portamento value set in
the program via the PORTA TIME slider in
the Editor.
7
Final output volume of
FI
127
Controls the entire audio output of the FI
(including any delay trails, etc). It is
independent of all program parameters. It
is smoothed and acts logarithmically.
Beware: if you use a keyboard or a MIDI
pedal to adjust the volume of the FI and
you disconnect it, the volume will only
return to the default maximum value if you
power the FI off and on again, change
program or change one of the Flexi
sources in the Editor.
11
Filter cutoff
64
Duplication of CC74. See below.
64
Sustain ON/OFF
0
If ≥64 then it switches ON; If <64, then it
switches OFF.
Sustain stops upon change of program.
65
Portamento ON/OFF
127
If ≥64 then it switches ON; If <64, then it
switches OFF.
66
FI ON/OFF
---
If ≥64 relay switches to ON. If <64, relay
switches to OFF. (This message will also
disengage the Tuner, putting the FI into
either the ON or OFF state, depending on
the value of the message sent.)
Go to Table of Contents
78