Panda-Audio Future Impact v3 - MIDI Implementation

MIDI Implementation
The FI will respond to the following standard MIDI messages received on the selected MIDI
channel:
MIDI CC /
Name
Default Function in
the FI
Default
Value
Notes
Note On
---
Active only in MIDI Mode. Also switches
the FI into MIDI mode.
Note Off
---
Active only in MIDI Mode.
Aftertouch
---
Velocity
Keyboard velocity
control of filter cutoff
---
Active only in MIDI Mode.
Pitch
Bend
---
Active only in MIDI Mode.
Program
Change
---
1...99 for programs 1...99.
1
LFO depth to VCF and
VCO
0*/127
*0 in SYNTH Mode only.
Modulation (CC1) is routed to both VCF
and VCO LFO Modu la tion. The depth set
in the program will be reached if CC1 is at
maximum (127).
(Practically speaking, the modulation
value(s) in the program will be multiplied
with the MIDI controller value / 127.)
Beware: if you use the FI with a keyboard
and set the Mod Wheel to minimum, CC1
will be at 0. If, at this point, you disconnect
the MIDI keyboard and instead play the FI
with your instrument via the audio input,
you will find that there is no LFO
modulation in the programs where you
would expect it; this is because CC1 is still
at 0. You will need to reset CC1 to its
default value of 127 by changing program,
adjusting a flexi slot in the Editor or
powering the FI off and on again.
Go to Table of Contents
77