25
3.
Touch an option, and then use the virtual keypad to change the field values.
Repeat for all desired options.
Use
to highlight an option, and then use to change the field
values
. Repeat for all desired options.
TIP: Use the ‘+’ and ‘-‘ buttons to toggle the Weekdays and Weekends options
ON/OFF.
4.
When correct times are set, select
Done to save the settings.
Run Schedule
After the schedule times have been set (per above instructions), you will use the Run Schedule
function whenever you want the schedule to take effect.
There are two methods for running the schedule, a) during a slideshow or b) from the
CALENDAR/CLOCK screen.
CAUTION: After you select the Run Schedule function, any user intervention will cancel the
activation (i.e., touching the screen, pressing remote control button) and the
schedule will not take effect unless you select this function again to re-activate.
Run Schedule from Slideshow
1. At the beginning of a slideshow, a Run Schedule button appears for approximately 10
seconds in the lower left corner of the screen; touch or press
ENTER to activate the
button.
2. To run the schedule when the
Run Schedule button is no longer displayed, touch the
screen and then the
Run Schedule button, or restart your slideshow and press ENTER
to select the
Run Schedule button when it appears.
A small timer clock will appear indicating the schedule is active, and then the DPF will
operate according to the set schedule.
Run Schedule from CALENDAR/CLOCK Screen
1. On the CALENDAR/CLOCK screen, touch the screen or press MENU.
2. Select Run Schedule.
A small timer clock will appear indicating the schedule is active, and then the DPF will
operate according to the set schedule.
Disable Schedule
After the schedule has been set (per above instructions), you can disable the schedule whenever
desired.
1. On the
CALENDAR/CLOCK screen, touch the screen or press MENU.
2. Select
Set Schedule.
To Next Page
Loading...
Need help?
General
