28
1. Follow the instructions beginning on page 25 to clean the
roller and the image sensor, and then follow the instruction
in “Initial Setup” on page 12 to prepare the scanner for
scanning.
2. Insert the calibration card as
shown. The scanner will scan
the pattern on the calibration
card and perform calibration to
the sensor inside automatically.
Note: Make sure that the calibration card is inserted in the
correct direction, otherwise the calibration won’t work.
Storingthe
PhotoLinkScanner
If the scanner will not be used for a prolonged period of time,
follow the instructions below to store the scanner for future use.
1. Disconnect the scanner from power supply.
2. Place the scanner and power adapter in a box or bag to
keep them from accumulating dust.
3. Place it in a cool and dry place, inaccessible to small
children.
4. After long-term storage, it is recommended that you clean
and calibrate the scanner before use.
To Next Page
Loading...
Need help?
General
