9
USER MANUAL
ENMultisystem digital 3CAN | 2xLIN interface
Integrated digital CAN and LIN interfaces allow connection to digital buses of a vehicle for reading
information (statuses) and controlling vehicles (commands). The LIN-interface can be used to control
Webasto ThermoTopEvo and Eberspacher Hydronic/Hydronic2 heaters.
!
see deTailed informaTion on loader.pandorainfo.com
868 MHz Radio interface
A built-in radio channel is necessary for the communication with the remotes stored in the
system memory. 868 MHz frequency provides high-quality data transfer in the conditions of of radio
interference of a modern city.
Temperature
The system can determine interior, engine and outside temperature. The following sources are used:
built-in temperature sensor, connector of an external temperature sensor, digital CAN-bus, values from
additional devices.
! defaulT values: inTerior TemperaTe – builT-in sensor; engine TemperaTure – exTernal sensor; ouTside TemperaTure
– can.
Synchronized clock of the baze unit
Built in clock is automatically synchronized with the built-in GPS/GLONASS receiver
! iT is required To seT correcT uTc Time zone using The mobile app or The online-service.
Integrated power back-up
A built-in battery allows extending operating time of the system in the armed mode to promptly
notify an owner in the cases of an unauthorized disconnection of the onboard power supply. Power
supply from the back-up battery can be also occur in case of a short time voltage drop at the time of
starting the engine. If the back-up battery is discharged, the system automatically starts charging it
when the main power supply is active.
icro-USB port
The system has a buil-in micro-USB port that is used for system configuration and update via the
Pandora Alarm Studio. The system can be power from the USB, so you can configure it before installation.
To Next Page
Loading...
Need help?
General
