15USER MANUAL
VIEW EVENT HISTORY
This menu allows viewing the event history stored in the remote control memory. The remote control
displays an event name and its time.
NOTE! ThE NumbEr Of EvENTs is limiTEd by ThE mEmOry Of ThE rEmOTE cONTrOl. usE Our iNTErNET sErvicE TO viEw mOrE
dETailEd EvENT hisTOry.
AUTOMATIC ENGINE START SETTINGS
This menu allows configuring the automatic engine start and stop settings. A synchronized real-
time clock in the remote control and the base unit and other autonomous system settings allow to
implement set of conditions of engine start and operation regardless of whether the remote control is
in the radio coverage zone or not.
NOTE! if yOu havE NOT savEd NEw sETTiNgs, rEmOTE aNd auTOmaTic ENgiNE sTarT sETTiNgs will rEmaiN ThE samE as
bEfOrE. ENgiNE sTarT via TEmpEraTurE is availablE ONly if TEmpEraTurE sENsOr is cONNEcTEd. auTOmaTic ENgiNE sTarT
sETTiNgs dON’T affEcT rEmOTE ENgiNE sTarT fuNcTiONs.
•
ENABLE
- this submenu switches on/off all automatic engine starts.
•
TIMER
- this submenu allows starting an engine every day at the scheduled time.
•
START TEMP
- this submenu allows starting an engine automatically when the engine temperature is
low.
•
WORK TIME
- This submenu determines the maximum engine operation time for automatic and
remote starts.
•
PERIODICALLY
- this submenu allows starting engine periodically with a configured time interval.
•
STOP TEMP
- this submenu determines the engine stop temperature.
CONTROL OVER AN ENGINE PREHEATER
This menu allows switching on/off an engine pre-heater.
SETTINGS AND ADJUSTMENT OF THE SENSORS
This menu allows controlling and adjusting sensors (shock/motion/tilt) sensitivity. SHOCK and additional
EXTERNAL sensors have separate sensitivity zones. Alarm zone triggers when there are considerable
impact on a sensor. If the alarm zone is triggered, the system will indicate it with light and sound alarm
for 30 sec. Warning zone triggers when there are minor impact on a sensor (the sensitivity of the warning
zone should be higher than the alarm level sensitivity for correct operation). Warning level is indicated by