ParaBody 220 - Page 9

9
STEP 7:
22
22
• Using hammer tap one 5/16 X 2” ROLL PIN (47)
thru LEFT PRESS HANDLE (7) until it is flush
with other side of HANDLE as shown in
FIGURE 6
8
6
40
7
FIGURE 6
STEP 6:
• Place LEFT PRESS HANDLE (7) onto PRESS
ARM (8). Make sure that the 5/16 X 2” ROLL
PIN (47) passes into the slot located in the plate
of the PRESS ARM (8)
FIGURE 7
7
36
34
47
6
• Once in place secure and tighten the LEFT
PRESS HANDLE (7) to PRESS ARM (8)
using one 3/8” WASHER (36) and one
3/8” LOCK NUT (34)
SLOT
0
1
2
345
6
1/2 1/2 1/2 1/2 1/2 1/2
NOTE:
Place PRESS ARM (8) upside down on floor as shown to complete this step
47
• Insert two 1/2” FLANGE BEARINGS (40) into
the LEFT PRESS HANDLE (7) as shown in
FIGURE 6
• Repeat STEP 6 for the RIGHT PRESS
ARM HANDLE (6)
• Repeat STEP 7 for the RIGHT PRESS
ARM HANDLE (6)
FLUSH SIDE
• IMPORTANT! Do not overtighten: PRESS
ARM should rotate freely