24 User’s Guide
Arming (see section 4.3).
Exit and Force Arm: Press and hold the [
FORCE] button for 3
seconds (see Note2) to start the Exit Delay (see section 4.1).
When the Exit Delay elapses, the system will switch to Force
Arming (see section 4.5).
4.7.4 One-Touch Force Arming
Press and hold the [FORCE] button for 3 seconds (see Note2) to
bypass any open Force Zones. For details on Force Arming,
refer to section 4.5.
4.7.5 One-Touch Bypass Programming
Press and hold the [BYP] button for 3 seconds (see Note2) to
access Bypass Programming Mode (see section 4.6).
4.8 KEYSWITCH ARMING
A keyswitch can be used to arm and disarm the system. A
keyswitch is assigned to and programmed to Stay Arm
(see section 4.4) or Regular Arm (see section 4.3) a
specific partition. A keyswitch can function as a Maintained
or Momentary keyswitch.
To arm the system using a Maintained Keyswitch, set the
keyswitch to the “on” position. To disarm the system set the
keyswitch to the “off” position.
To arm the system using a Momentary Keyswitch, set the
keyswitch to the “on” position then turn it back to the “off”
position. Repeating this sequence will disarm the system.
1686EU04.fm Page 24 Tuesday, August 13, 2002 10:01 AM
To Next Page
Loading...
Need help?
General
