26 User’s Guide
5.0 ADDITIONAL FEATURES
Each keypad must be Chime Programmed and Muted
separately. Keypad Muting must be re-programmed if
your system suffers a total power loss.
When you press and hold a button and the keypad
emits a “C
ONFIRMATION BEEP”, the chime feature
has been enabled for that zone or Keypad Muting
has been enabled for that keypad. If the keypad
emits a “R
EJECTION BEEP”, these features have
been disabled.
5.1 PROGRAMMING CHIME ZONES
This feature allows you to program which zones will be
“Chime Enabled”. A “Chime Enabled” zone will advise you
every time it is opened by causing your keypad to emit a
rapid intermittent beep tone (
BEEP-BEEP-BEEP-BEEP). Press
and hold any button from [1] to [10] for 3 seconds to
activate or deactivate Chiming for zones 1 to 10. For
example, press and hold the [1] button to enable chiming
on zone 1.
5.2 KEYPAD MUTING
Press and hold the [CLEAR] button for 3 seconds to enable
or disable keypad muting. When muted, the keypad will
only emit the “C
ONFIRMATION BEEP”, “REJECTION BEEP”, and
beep when a button is pressed.
1686EU04.fm Page 26 Tuesday, August 13, 2002 10:01 AM
To Next Page
Loading...
Need help?
General
