Paradox Magellan MG-6060 - Installation Further Continued; UIP-256 Universal In-Field Programmer Connection; X10 Transmitter Connection; Connecting a Paradox Memory Key (PMC-3)

Paradox Magellan Systems 9
Figure 8: On-site Connection
UIP-256 Universal In-Field Programmer
Connection
Magellan’s firmware can be upgraded locally using the UIP-256
Universal In-Field Programmer. The UIP-256 includes
proprietary PC software, cables to interconnect Magellan and a
PC, as well as two 9V batteries. Connect the UIP-256 as shown
in Figure 9 on page 9.
Refer to the Universal In-Field Programmer (UIP-256)
Instructions for more information.
Figure 9: Connecting the UIP-256
X10 Transmitter Connection
Magellan supports the X10 communication protocol. X10 is a
communication protocol for remote control of electrical devices
such as lamps and appliances. Communication is accomplished
through standard household electrical wiring using X10
transmitters and receivers. Configure Magellan, with the use of
an X10 transmitter, to automate a home. Connect the X10
transmitter as shown in Figure 10 on page 9.
Refer to the Magellan X10 Instructions on our website,
www.paradox.ca, for information on using and
configuring Magellan’s X10 feature.
Figure 10: Connecting the X10 Transmitter
Connecting a Paradox Memory Key (PMC-3)
When using a Paradox Memory Key with a Magellan console,
remove power (both AC and battery power) and connect the
memory key to the 5-pin connector on the back of the Magellan
console as shown in Figure 11 on page 9. Once connected, re-
apply power to the console. For more information, see
Programming Using a Paradox Memory Key on page 12.
Figure 11: Connecting a Paradox Memory Key (PMC-3)
306 Adapter
Back view of the
Magellan console.
Standard
DB-9 cable
(9-pin serial cable)
Computer
containing
WinLoad
software
4- to 10-pin cable
(supplied with
the 306 Adapter)
4-pin
connector
cable
Connect the 10-pin
cable of the UIP-256 to
the 10-pin connector of
the Magellan console.
Standard
DB-9 cable
(9-pin serial cable)
Download latest
Magellan
firmware from
www.paradox.ca
Back view of the
Magellan console.
UIP-256
Universal In-Field
Programmer
4-pin
RJ11
cable
X10 transmitter
1. Connect one end of the 4-
pin RJ11 cable into the
X 10 plug of the console.
2. Connect the other end of
the 4-pin RJ11 cable into
the X10 transmitter.
3. Plug the X10 transmitter
into a standard wall outlet.
1
2
3
Back view of the Magellan console.
Jumper ON:
Read from and/or write to memory key
Jumper OFF:
Write protected (read from memory key only)