Magellan & Spectra SP • Programming Guide
51
Communication Report Codes
Use worksheet 47 to record your settings for communication report codes. Sections [879] and [884] apply to both GSM and network (GPRS/GSM) communications.
See Communication Programming on page 42, for more communication features. In addition, refer to Description of Sections [966] and [967] on page 54, for clearing
and resetting codes.
Communication Restore Report Codes
Use worksheet 48 to record your settings for communication restore report codes. Section [881] applies to both GSM and network (GPRS/GSM) communications.
Software Options and Additional Timers
Use the following section to program software options and additional communication timers on your MG/SP control panel.
Additional Communication Timers
Use worksheet 49 to record your settings for sections [901] and [902]. For additional timers, see worksheets 38 and 40. Sections [901] and [902] are also applicable
when using a VDMP3 Plug-in Voice Dialer.
RF zone supervision lost 1 381 Loss of supervision - RF US Untype zone supervision
RF zone supervision restore 3 381 Supervision restore - RF UR Untyped zone restoral
RF module supervision lost 1 381 Loss of supervision - RF US Untyped zone supervision
RF module supervision restore 3 381 Loss of supervision - RF restore UR Untyped zone restoral
RF module tamper 1 145 Expansion module tamper ES Expansion device tamper
RF module tamper restore 3 145 Expansion module tamper restore EJ Expansion device restore
Paramedic alarm 1 1AA Medical MA Medical alarm
Zone forced 1 57A Zone forced XW Zone forced
Zone included 3 57A Zone included UU Zone included
Remote low battery 1 338 Battery failure on module YT Module battery fail
Remote low battery restore 3 338 Battery failure on module restore YR Module battery fail restore
Failed to arm 1 454 Failed to close CI Failed to close
Worksheet 47: Communication Report Codes
Section Data Description Section Data Description Section Data Description
[879]
___/___ PCS series RF jam
[880]
___/___ -
[884]
___/___
GSM lost communication
with panel
___/___ PCS series no service ___/___ IP Module no service ___/___ -
___/___
PCS series module
supervision lost
___/___ IP Module supervision lost ___/___ -
___/___
Receiver fail to
communicate (GPRS)
___/___
IP receiver fail to
communicate
___/___ -
Worksheet 48: Communication Restore Report Codes
Section Data Description Section Data Description
[881]
___/___ PCS series RF jam
[882]
___/___ -
___/___ PCS series no service ___/___ IP Module no service
___/___ PCS series module supervision lost ___/___ IP Module supervision lost
___/___ Receiver fail to communicate (GPRS) ___/___ IP receiver fail to communicate
Table 46: Description of section [900] (BabyWare options)
Section Option Description OFF ON
[900]
1Call back Disabled
Enabled
2 Automatic event buffer transmission Disabled
Enabled
= Default
Worksheet 49: Additional Communication Timers
Section Data Description Default
[901] ___/___/___ 000 to 255 rings Number of rings 008
[902] ___/___/___ 000 to 255 secs. (max 127) Answering machine override delay 030
Table 45: List of automatic report codes (Continued)
System Event Default Contact ID Report Code Default SIA Report Code
To Next Page
Loading...
Need help?
General
