Paradox SP7000 Installation Guide

Magellan & Spectra SP • Installation Guide
39
Wireless Keypad Options
Section [588]: Wireless Keypad Options
If enabled, the panel can wait for each of its assigned wireless transmitters to send a status signal within a specified time to confirm their presence and functionality.
Option [1] OFF= Keypad 1 Supervision Disabled
Option [1] ON = Keypad 1 Supervision Enabled (default)
Option [2] OFF= Keypad 2 Supervision Disabled
Option [2] ON = Keypad 2 Supervision Enabled (default)
Option [3] OFF= Keypad 2 Supervision Disabled
Option [3] ON = Keypad 2 Supervision Enabled (default)
Option [4] OFF= Keypad 2 Supervision Disabled
Option [4] ON = Keypad 2 Supervision Enabled (default)
Option [5] OFF= Keypad 2 Supervision Disabled
Option [5] ON = Keypad 2 Supervision Enabled (default)
Option [6] OFF= Keypad 2 Supervision Disabled
Option [6] ON = Keypad 2 Supervision Enabled (default)
Option [7] OFF= Keypad 2 Supervision Disabled
Option [7] ON = Keypad 2 Supervision Enabled (default)
Option [8] OFF= Keypad 2 Supervision Disabled
Option [8] ON = Keypad 2 Supervision Enabled (default)
Wireless Keypad Live Display Mode
Section [587]: Wireless Keypad Options
Option [8] OFF= Live Display Mode Disabled
Option [8] ON = Live Display Mode Enabled (default)
Wireless Repeater Programming
Sections [545] to [546] represent wireless repeater 1 and 2 respectively.
The wireless repeater module will improve the range of your system by retransmitting information from zones, PGMs, wireless keypads and the control panel. Note
that all remote control signals are always repeated. You can have two RPT1 per system. The wireless repeater also provides one PGM and one zone input with
two-way wireless communication with the panel.
How Do I Assign Wireless Repeaters to the Panel?
1. Press the [
ENTER] key.
2. Enter your [
INSTALLER CODE] (default: 0000 / 000000) or [MAINTENANCE CODE] (empty by default)
3. Enter the desired [
SECTION NUMBER] (from sections [545] to [546]).
4. Enter the 6-digit [
SERIAL NUMBER] of the wireless repeater.
How Do I Delete Assigned Wireless Repeaters?
1. Press the [
ENTER] key.
2. Enter your [
INSTALLER CODE] (default: 0000 / 000000) or [MAINTENANCE CODE] (empty by default)
3. Enter the desired [
SECTION NUMBER] (from sections [545] to [546])
4. Press the [0] key six times to clear the serial number.

Paradox SP7000 Specifications

General

Partitions	2
Event Buffer	256 events
Wireless Zones	32
PGM Outputs	2
Compatibility	Paradox modules and accessories
Communication	GSM, IP
System Type	Hybrid
Power Supply	16.5VAC
Backup Battery	7Ah
Bus	4-wire (Digiplex EVO)