Bulletin HY25-1135-M1/US
Owner’s Manual
Parker Hannifin Corporation
Chelsea Products Division
Olive Branch, MS 38654 USA
17
Wire Shift PTO
6 and 8-Bolt PTOs
Cable Control Installation Instructions*
1. Find a suitable area on the dash to install the cable control (328346-10X) and the control plate
(68-P-18) indicator light.
Optional Location: As an option the control cable and knob can be located through floor. Using this
option the control plate and indicator light should still be located on dash, in close proximity.
NOTE: The location of the cable control and the control plate should be as close to each other as
possible and easily accessible by the driver or operator, but should not be an obstacle to driver
movement nor interfere with other controls, instruments, or equipment.
2. CAUTION: Before drilling any holes, make sure there is adequate room on both sides through dash
wall, drill a 1/2" (12.7 mm) diameter hole for the control cable. [1]
3. Install the control cable on the dash using the hex nuts supplied with the cable. The knob can then
be screwed into place [2]. The length of cable can then run through the firewall and back to the PTO
— making sure it is kept away from the exhaust, moving parts, etc.
NOTE: Do not kink the cable. In order for the cable to operate properly, there can be no bends smaller
than 6 inch radius. Total bends in the cable should not exceed 360° (example - four 90° bends in cable).
Fig. 20
*All six bolt wire shifts with the exception of the reversible, dual shift units, and some gear boxes.
4. Using the template found on page 14 (SK-168) drill the necessary holes for the control
plate-indicator light.
5. Install the control plate (68-P-18) stick on decal and indicator light on the dash using the hardware
supplied in the 328751-1X installation kit (Fig. 20).
To Next Page
Loading...
