EasyManua.ls Logo

Parker 221 Series - Shift Option S, T or U - Elec;Air Shift 221;290;442;447;489;660;680 Series (SK-297 Rev J)

Parker 221 Series
56 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Bulletin HY25-1135-M1/US
Installation Sketches
Parker Hannifin Corporation
Chelsea Products Division
Olive Branch, MS 38654 USA
30
Owner’s Manual
6 and 8-Bolt PTOs
GENERAL
WARNING: Connect directly to air supply. Do not use tubing between air supply and pressure protection valve.
CAUTION: When installing nylon tubing avoid sharp angles, exhaust and manifold systems.
ImPORTANT: When this installation is used on vehicles with automatic transmissions the, PTO drive gear must be stopped before shifting.
NOTE: Air control value must be fitted inside a waterproof housing when instlled outside the driver’s cab.
Air Shift Installation Kits: 328388-65X
328388-72X
328388-79X
(SK-297 Rev J)
378416 Hex. Nipple
Air Supply
379042 Male Connector
379042 Male Connector
379042 Male Connector
To Dump Pump
Shifter Lower Port
To Dump Pump
Shifter Raise Port
379044-6 1/4" Nylon Tubing
379044-6 Nylon Tubing
379904 Push Connector
Connect to Indicator
Switch on Air Shift
Cover Ass’y
379640
Booted Pin
Connector
Battery or
Ignition
379000 Fuse
Holder Ass’y
w/10 AMP
Fuse
Black
Wire
379252 Butt
Connector
379664 Red L.E.D. 12 V
Indicator Light Assembly
Red Wire
Cab
PTO
IN
TIP
EX
LOW
OFF
Exhaust Port May
Be Plumbed to
Exhaust Outside
of Cab
NOTE: Connect Plastic Tubing to the
Push Connect (Air Shift Cover Ass’y)
378414 Pressure Protection Valve
Opens at 70 PSI
Shift Option S, T or U
Elec/Air Shift
221/290/442/447/489/
660/680 Series

Table of Contents

Related product manuals