Publication DNET-UM072C-EN-P - July 2004
Make Cable Connections 3-7
5. Firmly twist the bare wire ends to eliminate loose strands.
6. Loop each bare wire as shown below so you may insert the terminal
block into the clamping cavity.
7. Firmly tighten the terminal block screw to clamp the bare wire end in
place.
8. After all cables are terminated, secure the cover and tighten the screws
to obtain the washdown rating.
9. Tighten all wire glands.
ATTENTION
Be certain that you use insulating tubing (included with the
accessory kit) on bare drain wire.
PowerTap Tap - 1485T-P2T5-T5
trunk
power supply
trunk
41758
To Next Page
Loading...
