Parker H Series - Go on Line; Chapter Summary and Whats Next

Publication PSS-UM001A-EN-P – December 2016
4-6 Confi gure the DeviceNet Scanner Subnet
Go On Line
After you set confi guration parameters, your scanner must go on line
to accept the confi guration changes. Follow these steps:
1. Use the Network pulldown to go on line.
The software prompts you to save your confi guration changes.
2. Choose your scanner’s network and apply the changes, as shown
below.
Chapter Summary and What’s Next
In this chapter, you learned how to confi gure the scanner.
Move to Chapter 5 to learn how to add the H Series
Fieldbus DeviceNet adapter to the DeviceNet scanner’s
scanlist.
1. Click on Network.
2. Click on Online.
Click Yes.
Select the DeviceNet
network subnetwork.
This selection accesses
the PointBus to configure
the adapter on the
DeviceNet network.
Click OK to apply the
data to your scanner.