Publication PSS-UM001A-EN-P – December 2016
Table of Contents i
Chapter 1
Install the H Series Fieldbus Mount the Adapter and I/O Base ................................................................ 1-1
DeviceNet Adapters
Set the Node Address ................................................................................. 1-1
Wire the DeviceNet Adapters ...................................................................... 1-2
PSSCDM12A ........................................................................................ 1-2
PSSCDM18PA ...................................................................................... 1-2
DeviceNet Auxiliary Power ................................................................... 1-2
Chapter Summary and What’s Next ............................................................ 1-2
Chapter 2
What Is the H Series Fieldbus Use the Adapter .......................................................................................... 2-1
DeviceNet Adapter? Set Subnet/Backplane Baudrate .......................................................... 2-2
Set Subnet/Backplane I/O Module Addresses ..................................... 2-2
Confi gure the Subnet I/O ...................................................................... 2-2
Confi gure the Primary DeviceNet Network .......................................... 2-2
Remove and Reinsert Modules on the Backplane ............................... 2-2
Understand the DeviceNet Network and Subnet ........................................ 2-3
DeviceNet Network ............................................................................... 2-3
Backplane/Subnet Network .................................................................. 2-3
Adapter Features ........................................................................................ 2-4
Communicate Through the Adapter ............................................................ 2-8
Map the Data ........................................................................................ 2-8
Overview of the Communication Process ............................................ 2-8
Image Table Mapping ........................................................................... 2-9
Communicate With I/O Modules ............................................................... 2-10
Use Diagnostic Tables .............................................................................. 2-11
Chapter Summary and What’s Next .......................................................... 2-12
Chapter 3
Use Auto Start Mode Why Use Auto Start Mode? ........................................................................ 3-2
What Does Auto Start Mode Do? ......................................................... 3-2
How Is I/O Data Mapped Using Auto Start Mode? ............................... 3-2
Requirement To Using Auto Start Mode ............................................... 3-2
Install the I/O Module .................................................................................. 3-3
Remove the Module From the Mounting Base ..................................... 3-3
Use RSNetWorx for DeviceNet ................................................................... 3-4
Begin Auto Start Mode ................................................................................ 3-5
Use Custom Confi guration .......................................................................... 3-6
Chapter Summary and What’s Next ............................................................ 3-6
To Next Page
Loading...
