Parker H Series - Chapter Summary and Whats Next; Wire the Devicenet Adapters; Devicenet Auxiliary Power; Psscdm12 A

Publication PSS-UM001A-EN-P – December 2016
1-2 Install the H Series Fieldbus DeviceNet Adapters
Wire the DeviceNet Adapters
Following are wiring instructions for the DeviceNet Adapters.
Male In Connector
PSSCDM12A
Female Out Connector
(view into connector)
Pin 1 - Drain
Pin 2 - +V
Pin 3 - -V
Pin 4 - CAN_High
Pin 5 - CAN_Low
Male In Connector
PSSCDM18PA
Female Out Connector
(view into connector)
Pin 1 - Drain
Pin 2 - +V
Pin 3 - -V
Pin 4 - CAN_High
Pin 5 - CAN_Low
Male In Connector
DeviceNet Auxiliary Power
(view into connector)
Pin 1 - User Power +
Pin 2 - Adapter Power +
Pin 3 - Adapter Power -
Pin 4 - User Power -
Chapter Summary and What’s Next
In this chapter, you learned how to install and wire your
DeviceNet adapter. Move to Chapter 2 to learn about
the H Series Fieldbus DeviceNet adapters.
Make sure all connectors and caps are securely tightened to
properly seal the connections against leaks and maintain IP67
requirements.
!
ATTENTION