Parker H Series - Page 75

H Series Fieldbus 24 VDC Analog Input Modules, Series A (PSSNACM12A, PSSNAVM12A) E110P
4
Install the Analog Input Module
ToInstalltheAnalogInputModule,ProceedasFollows:
1.
Using a bladed screwdriver, rotate the keyswitch on the mounting
base clockwise until the number 3 aligns with the notch in the
base.
2. Position the module vertically above the mounting base. The
module will bridge two bases.
3.
Push the module down until it engages the latching mechanism. You
will hear a clicking sound when the module is properly engaged.
The locking mechanism will lock the module to the base.
Remove the Analog Input Module From the
Mounting Base
ToRemovetheModulefromtheMountingBase:
1. Put a flat blade screwdriver into the slot of the orange latching
mechanism.
2. Push the screwdriver toward the I/O module to disengage the
latch. The module will lift up off the base.
3. Pull the module off of the base.
MOD
NET
PSSNACM12A
Analog Current In
0
1
0
1
Module Will Bridge Two Bases