2120
BEFORE USING THE BRUSH CUTTER
BEFOR USING THE BRUSH CUTTER
NOTICE
THIS FUEL MUST BE
MIXED WITH 2 STROKE
OIL AT A 40:1 RATIO
(PETROL:OIL)
40:1
1
INSPECT THE BRUSH CUTTER
Check the Brush Cutter is not damaged and all components
are in good working order before use. Regular periodic
inspection is required to ensure the Brush cutter is
suitable for the task. Before using the Brush Cutter a risk
assessment should be carried out respecting the legislation
in the country of use.
The locking washers may come pre-installed on the hub
of the machine. The hub will need assembling in different
congurations to t the appropriate attachments. Washer 'A'
needs to be in place to attach both the Spool and the
3 tooth blade.
2
LOCKING WASHERS
NOTICE
THE HUB ON THIS MACHINE
COMES PRE-ASSEMBLED
• Please follow all instructions carefully when tting the various cutting attachments
• Do not start the Brush Cutter without making sure the cutting attachments are tted properly.
WARNING!
• This Brush Cutter is not supplied with any fuel or oil within the engine, there is only trace left from testing.
• The fuel for this machine must be mixed with 2 stroke oil at a 40:1 ratio (Petrol:Oil)
• Do not start without adding a 40:1 ratio (Petrol:Oil) rst, failure to do so will damage the engine.
To Next Page
Loading...