63
62
SET SPARK PLUG GAP
1
MAINTENANCE & CARE
Before starting work
After nishing work or daily
After each refuelling stop
Weekly
Monthly
Yearly
If problem
If damaged
As required
OTHER
Complete machine
Visual inspection (condition, leaks) X X
Clean X
Cutting Attachment
Visual inspection X X
Replace X
Check tightness X X
Cutting Attachment Guard Attach X
Control Handle Check operation X X
Metal Cutting Attachment Sharpen X X
All accessible screws and nuts Re-tighten X X
Anti-vibration Elements Check X X X
• Never touch the coil pack/spark plug when the machine is running as there is a risk of electric shock.
WARNING!
SET THE SPARK PLUG
GAP BETWEEN
0.5mm - 0.7mm
SPARK PLUG MAINTENANCE
• Once the engine has cooled, twist off the spark plug
cover/coil pack lead.
• Carefully remove the spark plug using the spark plug
wrench supplied.
• Clean the spark plug with a wire brush (not supplied) to
remove any deposits.
• Using a feeler gauge set the gap between 0.5 of 0.7mm.
• Install the spark plug carefully by hand being careful not
to cross the threads.
• After the spark plug is seated correctly, tighten with the
wrench supplied.
MAINTENANCE & CARE
To Next Page
Loading...