21
Quick Start: “Dispensing by Weight”
Equipment: You will need the following items to get started:
Parker
Part N°.
Description
Quantity
N/A Solution Reservoir 1 pc
200-LABT-1682
LabTec™ CP-200 w/1082 Head
1 pc
100-VIPER6 Mettler ICS425 6kg Scale 1 pc
400-124 Silicone #24 Tubing 25ft (1pkg)
400-491A Dispensing Tips 1 pkg
N/A Container to be filled 1 pc
Hardware Setup:
1.
Unpack all the components, visually identify and inspect for damage.
2.
At the dispensing station, place the solution reservoir to the far left, the LabTec™ to its right and
the scale to the right. Position the dispensing tip over the container to be filled.
3.
Connect the interface cable between the LabTec™ and the scale paying close attention to the
labels on the cable and those on the rear of the LabTec™.
4.
Plug in and power up both units.
5.
Cut approximately 10 feet of the #24 tubing and install the dispensing tip on one end. Mount that
end of the tubing in the tubing clamp and position it so that it is just above the container.
6.
Route the tubing to the LabTec™, open the head by rotating the lever 180 degrees counter
clockwise, and place the tubing over the upper set of rollers. Confirm that the tubing is under
the centering springs and close the head by rotating the lever back to its original position.
7.
Route the remaining tubing to the solution reservoir and attach it as appropriate.
Note: If you purchased both the LabTec™ and the scale from Parker, all the
settings for both
units have been configured. If the display shows “Scale Error, Press any key”
after trying to
initialize the scale, check Setup: Scale: Scale Manuf., and confirm the proper
choice for the
scale you have purchased. If the scale was not purchased from Parker, contact Parker
Technical Customer Service for instructions on setting up your scale.
To Next Page
Loading...
