7
Installation & Start Up
Installation of the LabTec™ System must be carried out only by trained personnel in accordance with
the relevant regulations and this operations manual.
Make sure that the technical specifications and input ratings of the LabTec™ are observed.
See “LabTec™ Specifications”.
The protection provided by this equipment may be impaired if the LabTec™ is used in a manner
inconsistent with this manual or for purposes not specified by the manufacturer.
Maintenance & Cleaning
The LabTec™ is practically maintenance free. The SciPres
®
sensors used with the system come
pre-calibrated from the factory and require no maintenance. The ™ peristaltic pump head should
periodically have tubing debris cleaned from it, but requires no lubrication.
Parker recommends a factory cleaning, testing and recalibration be done to your
LabTec™ at least
once a year, to maintain the accuracy of the unit and reduce your downtime.
Contact Customer Service for an RGA or contact your Territory Manager. We can design a
preventative maintenance program specifically for your company.
To remove dust, dirt and stains, the outer surfaces of the LabTec™ may be wiped using a soft,
non-fluffing cloth moistened with water. If required, you may also use a mild detergent or 2-propanol.
The SciPres
®
sensors may be sanitized with 0.1 Molar NaOH, or 2-propanol. They may be autoclaved
up to twice, and may be gamma-irradiated.
To Next Page
Loading...
