Parker SciLog LabTec - Back Panel: Interface Options

28


3.0 Back Panel: Interface Options
P1
Printer
P2
External I/O
P3
S1
Temperature
The LabTec™ back panel provides interfacing ports for:
• Parker Printer (P/N: 080-095) or PC RS-232 connection: Female DB9, labeled
“Printer”.
• Electronic Scale: Male DB9, labeled “S1”. (S2 and S3 are not utilized in the LabTec™.)
• Foot Switch (P/N: 080-059) or SciLog
®
SciCon
®
Monitor: Male DB37, Labeled “External I/O”.
• SciLog
®
SciPres
®
Pressure Sensors: 3 RJ11 jacks, one for each pressure sensor.
Labeled “P1, P2, P3”. The LabTec™ uses only one sensor. (Do not connect the LabTec™ to a
telephone system, these are for the sensors only.)
• SciLog
®
SciTemp
®
Temperature Sensor: Conxall 2 pin connector. Labeled “Temperature”.