HY13-1527-M1/US
Torqmotor™ Service Procedure
TF, TG, TH and TL Series
Parker Hannifin Corporation
Hydraulic Pump/Motor Division
Greeneville, TN 37745 US
41
Tips for Maintaining the Torqmotor™ Hydraulic System
• Adjust uid level in reservoir as necessary.
• Encourage all operators to report any malfunction or accident that may have damaged the hydraulic system
or component.
• Do not attempt to weld any broken Torqmotor™ component. Replace the component with original equipment
only.
• Do not cold straighten, hot straighten, or bend any Torqmotor™ part.
• Prevent dirt or other foreign matter from entering the hydraulic system. Clean the area around and the ller
caps before checking oil level.
• Investigate and correct any external leak in the hydraulic system, no matter how minor the leak.
• Comply with manufacturer’s specications for cleaning or replacing the lter.
CAUTION: Do not weld, braze, solder or any way alter any Torqmotor™ component.
CAUTION: Maximum operating pressure must not exceed recommended Torqmotor™ pressure
capacity.
CAUTION: Always carefully inspect any system component that may have been struck or damaged
during operation or in an accident. Replace any component that is damaged or that is questionable.
CAUTION: Do not force any coupling onto the Torqmotor™ coupling shaft as this could damage the unit
internally.
Parker extends close technical cooperation and assistance. If problems occur which you cannot solve, please
contact your local Parker approved Distributor or Parker Technical Support. Our phone number and fax
number and address are on the back cover of this manual.
Tips
To Next Page
Loading...
Need help?
General
