HY13-1527-M1/US
Torqmotor™ Service Procedure
TF, TG, TH and TL Series
Parker Hannifin Corporation
Hydraulic Pump/Motor Division
Greeneville, TN 37745 US
8
• Clean, petroleum-based solvent
• Emery paper
• Vise with soft jaws
• Air pressure source
• Arbor press
• Screw driver
• Masking tape
• Breaker bar
• Torque wrench-ft. lbs. (N m)
• Sockets: 1/2 or 9/16 inch thin wall, 1 inch
• Allen Sockets: 3/16, 3/8 inch
• Adjustable crescent wrench or hose tting wrenches
• SAE 10W40 SE or SF oil
• Special bearing mandrel for TH Torqmotors (consult factory)
• Special bearing mandrel for TF, TG & TJ Torqmotors (SEE FIGURE 1)
• Feeler gage .005 inch (.13 mm)
• TH Torqmotors require blind hole bearing puller for a 1.575 inch dia. (40.0 mm) and 2.130 inch dia. (54.1 mm)
bearings.
• TF, TG & TL Torqmotors require blind hole bearing puller for 1.400 inch dia. (35.6 mm) and 2.130 inch dia. (54.1
mm) bearings.
• Clean corrosion resistant grease. Part #406018 is included in each seal kit. Recommended grease is Parker
Specication #045236 or Mobil Mobilith SHC
®
460
NOTE: The available service seal kits include the recommended grease as a grease pack #406018
CAUTION: Mixing greases that have different bases can be detrimental to bearing life.
Tools and Materials Required for Servicing
To Next Page
Loading...
Need help?
General
