48
GB MT
Green LED lights up: Battery is charged.
Red LED lights up: Battery charging.
Red LED ashes:Battery overheated
Red + green LEDs ash: Battery defective
Operation
Working Notes
• When cutting, observe the country-
specic / local regulations.
• Do not cut during commonly applica-
ble quiet periods.
• Solid objects such as stones, metal
pieces or similar must be removed.
These can be thrown out and therefore
result in personal or property damage.
• When cutting in high bushes or
hedges, the working height should be
at least 15 cm. This prevents the risk to
animals, e.g. hedgehogs.
• Always hold the equipment rmly and
securely with both hands.
• Cut only grass and weeds with the
spool and 3-tooth blade! The clearing
blade can be used to cut thickets and
small logs up to 20 mm in diameter.
Be aware of roots or tree stumps – risk
of tripping.
• Work considerately and endanger nobody
when cutting. Work quietly and carefully.
• Work only in adequate visibility and
lighting conditions.
• Keep an eye on the cutting head.
• Never cut above shoulder height.
• Never replace the plastic cord with a
steel wire – risk of injury and damage.
• Do not work on a ladder.
• Work only on rm and stable bases.
• Avoid an abnormal body posture.
Ensure that your footing is secure and
keep your balance at all times.
• Change your working position at regu-
lar intervals in order to prevent becom-
ing tired on one side of your body.
• If the cutting head becomes jammed,
turn the device off immediately, re-
move the spark plug connector and
then remove the cause of the blockage.
Removing/mounting the
protective cover extension
The protective cover extension must be re-
moved when using the 3-tooth blade.
The edge of the extension must be tted
when using the spool.
Removing the extension of the
protective cover, Fig.
:
1. Unclip the three sides of the click lock
(50) using a slotted screwdriver.
2. Remove the protective cover extension
(25).
Fitting the protective cover extension,
Fig.
:
1. Clip in the three sides of the click lock
(50) using a slotted screwdriver.
Clean the extension and protective
cover of the device after each use.
Adjusting the carrying har-
ness eyelet/balancing out
the device
Select the correct position for the carrying
harness eyelet according to whether you
are using a spool or blade.
Fig.
:
The thread spool or blade (depending on
which is selected) should be situated as fol-
lows without needing them to be touched
by hand:
The thread spool should lie gently
on the ground.
To Next Page
Loading...