Parkside PPBS 3 A1 - General Storage Instructions; Storage; Storage During Working Breaks; Transport

56
GB MT
Storage
General Storage Instructions
• Clean and maintain the device and ac-
cessories carefully before storage.
• Keep the equipment in a dry and dust-
proof place out of reach of children.
• Do not wrap the equipment in plastic
bags, as damp and mould may form.
• Do not lie the device down on the pro-
tective cover.
• Use transport protection (
A
28/29)
when storing the blades.
• The cable holders (
A
10) should hold
the device cable (
A
11) in position.
Do not remove the cable holders, even
when storing the device.
Storage During Working
Breaks
Non-observance of the storage in-
structions can cause starting
problems or permanent damage as a result
of fuel residues in the carburettor.
In case of working breaks of less
than 3 months:
1. Drain the fuel tank (
A
4) in a well-
ventilated place.
2. Start the engine and allow it to tick
over until the engine stops and the car-
burettor is free of fuel.
3. Allow the engine to cool (approx.
5minutes).
In case of working breaks of more
than 3 months:
4. Loosen the spark plug (
58) with a
spark plug wrench (
30) (see “Chang-
ing/Adjusting the Spark Plug”).
5. Pour a teaspoon of pure 2-stroke oil into
the combustion chamber and pull the
starter cable slowly several times to dis-
tribute the oil inside the engine.
6. Reinsert the spark plug (
58).
Transport
• When it is being transported, the de-
vice must be switched off and the spark
plug connector (
A
1) removed. Do not
transport the device when it is idling.
• Carry the device with one hand on the
upper shaft tube and the other hand
on the lower shaft tube (
A
14+19)
in order to avoid coming into contact
with dangerous parts when transport-
ing it (e.g. hot engine, cutting unit).
• Use the blade guard (
A
28/29) when
transporting the blades.
• Maintain a safe distance from other
people when transporting the device.
• Do not transport the unit upside down,
as otherwise fuel might leak out.
• Before transporting between two loca-
tions, empty the fuel tank with a petrol
suction pump.
Do not empty the fuel tank indoors,
near re or when smoking. Gas va-
pours can cause explosions or re.
Transporting in a vehicle: Secure
the device against tipping over and
damage. Ensure the device is securely
positioned.
Disposal and protection
of the environment
Remove the battery from the device and re-
cycle the device, battery, accessories and
packaging in an environmentally-friendly
manner. Drain the petrol tank carefully
Do not dispose of waste oil and petrol
residues in the sewage system or down the
drain. Dispose of waste oil and petrol rem-
nants in an environmentally friendly way –