Parkside PSTD 800 E4 - Meaning of the Safety Information; Pictograms and Symbols; Safety Information; Technical Data

GB
MT
23
Technical data
Jigsaw ......................PSTD 800 E4
Rated voltage U ............... 230V∼, 50Hz
Rated output P ................................800W
Length Power cord ................................3m
Protection class ..⧈ II ( double insulation )
Weight ..............................................2.2kg
Idle stroke rate ....................0–3100 min
−1
Stroke length ....................................22mm
Blade thickness .............................≤1.6mm
Cutting depth
– wood .........................................≤80mm
– metal ............................................≤8mm
Bevel cutting
..−45°; −30°; −15°; 0°; 15°; 30°; 45°
Sound pressure level (L
pA
)
......................................94.1 dB; K
pA
=5dB
Sound power level (L
WA
)
–Measured .............102.1 dB; K
WA
=5dB
Vibration (a
h
)
– wood ..............5.737 m/s²; K=1.5m/s²
– metal ..............6.079 m/s²; K=1.5m/s²
Levels of noise and vibration were determ-
ined according to the standards and regu-
lations in the declaration of conformity.
The specified total vibration value and the
stated noise emission value have been
measured according to a standardised
test method and can be used to compare
one power tool with another. The specified
total vibration value and the stated spe-
cified noise emission value can also be
used for a provisional assessment of the
load.
WARNING! The vibration and noise
emissions may deviate from the specified
values during actual use of the power tool,
depending on how the power tool is be-
ing used. Try to keep the exposure to vi-
brations as low as possible. An example
of a measure to reduce vibration exposure
is limiting the working hours. All parts of
the operating cycle have to be considered
while doing so (for example, times when
the power tool is switched off and times
when it is switched on but running without
any load).
Safety information
This section deals with the basic safety in-
structions for using the device.
Meaning of the safety
information
DANGER! If you do not observe this
safety instruction, an accident will occur.
The result of which is severe bodily injury
or death.
WARNING! If you do not observe
this safety instruction, an accident may
occur. The result of which is likely severe
bodily injury or death.
CAUTION! If you do not observe this
safety instruction, an accident will occur.
The result of which is likely minor or mod-
erate bodily injury.
NOTICE! If you do not observe this safety
instruction, an accident will occur. The res-
ult of which is possible damage to prop-
erty.
Pictograms and symbols
Symbols on the device
Read the instruction manual
Protection classII (double insula-
tion)
Waste electrical and electronic
equipment (WEEE) must not be dis-
posed of with domestic waste.