11Installation
If your vehicle does not have an athermic windshield, stick the GPS Receiver on the
dashboard. The side where the star-shaped logo is must be visible.
select the support location carefully: once stuck, it will be difficult to change it
without affecting the fixation quality ;
clean the area with an appropriate cleaning product before sticking the support ;
once you have stuck the support on the dashboard, wait for approximately 2 hours
without handling it.
Note : Once the GPS receiver is connected to the Parrot ASTEROID Mini, the GPS receiver
light stays off while searching for a GPS signal. The light blinks in white as soon as a signal
is detected.
Installing the USB cables
Connect the USB cables to the Parrot ASTEROID Mini. We recommend you connect
all audio cables to the Parrot ASTEROID Mini even if you do not plan on using them.
Route the audio cables to a suitable location in your vehicle such as the glove box or
arm rest compartment. It may be necessary to drill a hole in your dashboard to do so.
Avoid using USB extension cables.
Installing the screen
Warning: Avoid any installation which could hinder the use of any important command or
hinder the driver's visibility. Do not install the Parrot ASTEROID Mini in the airbag
deployment area or in a possible head impact area. Make sure it is not exposed to the air
stream from air vents.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
