Parrot Bebop - Charging the battery; Installing the battery; Using the hull

5Before you begin
Charging the battery
1. Insert the plug converter corresponding to your country to
the charger.
2. Plug the battery into the charger.
3. Plug the charger into the mains.
> The charger led lights up in red when charging. Once the
battery is fully charged, the led turns green. The battery
takes about 1 hour to charge.
Installing the battery
1. Plug the battery to the Parrot Bebop Drone's power cable (A). If necessary, pull the
string to access the power cable.
2. Slide the battery into its compartment.
3. Attach the strap to secure the battery (B).
Using the hull
To use the Parrot Bebop Drone indoors:
1. Install the hull protectors to protect the Parrot Bebop Drone in case of collision.
2. Launch the FreeFlight 3 application.
3. Press , then Flight settings.
4. Activate the Hull button.